Li3VO4 has been regarded as a new-type anode of lithium-ion batteries in recent years, which has a high theoretical specific capacity of 394 mAh g(-1), a proper potential for Li(+) insertion/deinsertion (∼1 V), and a good rate capacity. However, its low initial Coulombic efficiency, poor conductivity, and poor cycle performance restricts its development. In order to figure out the cause of the low initial Coulombic efficiency of Li3VO4 material, the nanosized Li3VO4 material was synthesized by citric acid-assisted sol-gel method. The lithium storage behaviors of the prepared Li3VO4 material were studied by in-situ XRD and in-situ EIS techniques. In-situ XRD results indicated that there was irreversible phase transformation of Li3VO4 during the initial charging/discharging process. In-situ EIS experiment was performed during the potentiostatic intermittent titration technique (PITT) process to discuss the formation of the solid electrolyte interface (SEI) on the Li3VO4 and the kinetics of lithium-ion diffusion. It is worth pointing out that this is the first time to prove the existence of SEI on Li3VO4 during the initial charging/discharging process by in-situ EIS experiment. It turned out that the irreversible phase transformation and the formation of SEI on Li3VO4 were the two important reasons causing the low initial Coulombic efficiency of Li3VO4 material.
Keywords: PITT; in-situ EIS; in-situ XRD; low initial Coulombic efficiency; nanosized Li3VO4.