In order to assess short-term exposures to ethylene oxide, formaldehyde and glutaraldehyde in a sterilization process, the authors conducted continuous environmental monitoring of these chemicals in the breathing zone of workers in 2 hospitals. The arithmetic mean of ethylene oxide was 1.2 ppm near unventilated cabinets housing sterilizing materials, and environmental concentrations of ethylene oxide could not be reduced under threshold limit values time weighted average by only managing general ventilation. Environmental concentration of formaldehyde was lower in a properly ventilated pathology division in which no large specimens were stored (0.3 ppm) than in the pathology division where large specimens were stored (2.3 ppm). Although environmental concentrations of glutaraldehyde in an endoscopy unit with proper general ventilation were not detectable, environmental concentration levels in an endoscopy unit without general ventilation system were 0.2 and 0.5 ppm. According to the results of environmental monitoring in the breathing zone of workers, extremely high concentrations were observed in some work practices (ethylene oxide, 300 ppm; formaldehyde, 8.6 ppm; glutaraldehyde, 2.6 ppm). In order to avoid occupational exposures to these chemicals and prevent potential chronic and acute health hazards, good communications with these chemicals, good work practices, appropriate personal protective equipment, and engineering controls should be required.